Table of Contents
Advertisement
Serial Port
The system board is equipped with an onboard serial port at location CN4 for COM 1. It
is also equipped with a 9-pin connector at location J5 for COM 2. These serial ports are
RS-232 asynchronous communication ports with 16C550A-compatible UARTs that can
be used with modems, serial printers, remote display terminals, and other serial devices.
To connect COM 2, insert the connector that is attached to the serial port cable to J5.
Make sure the colored stripe on the ribbon cable is aligned with pin 1 of J5.
BIOS Setting
Configure the serial ports in the Integrated Peripherals submenu ("Super IO Device"
section) of the BIOS. Refer to chapter 3 for more information.
page 44
MBATX-945G-VGA User's Guide
Advertisement
Table of Contents
