Kontron MBATX-945G-VGA User Manual page 55

Adding a Second IDE Disk Drive
When using two IDE drives, one must be set as the master and the other as the slave.
Follow the instructions provided by the drive manufacturer for setting the jumpers and/or
switches on the drives.
The system board supports Enhanced IDE or ATA-2, ATA/33, ATA/66 or ATA/100 hard
drives. We recommend that you use hard drives from the same manufacturer. In a few
cases, drives from two different manufacturers will not function properly when used
together. The problem lies in the hard drives, not the system board.
Important: If you encountered problems while using an ATAPI CD-ROM drive
that is set in Master mode, please set the CD-ROM drive to Slave mode. Some
ATAPI CD-ROMs may not be recognized and cannot be used if incorrectly set in
Master mode.
BIOS Setting
Configure the onboard IDE in the Integrated Peripherals submenu ("OnChip IDE
Device" field) of the BIOS. Refer to chapter 3 for more information.
MBATX-945G-VGA User's Guide page 55