Snmp Inform Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

6.3.7 SNMP Inform Commands

6.3.7.1 show snmpinform
This command displays SNMP inform receivers. SNMP Inform messages are sent across a network to
an SNMP Network Manager. These messages alert the manager to events occurring within the switch or
on the network. Six inform receivers are simultaneously supported.
Syntax
show snmpinform
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Inform Flags: Shows SNMP Inform is Enable or Disable.
SNMP Inform Retries: Shows how many times should SNMP Inform retry when not success.
SNMP Inform Timeout: Shows how long should SNMP Inform wait when not success.
SNMP Inform Name: The community string of the SNMP trap packet sent to the trap manager. This
may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address/Hostname: The IP or IPv6 Address or domain name to receive SNMP Informs from this
device.
SNMP Version: The trap version to be used by the receiver.
SNMP v2 – Uses SNMP v2 to send traps to the receiver.
SNMP v3 – Uses SNMP v3 to send traps to the receiver.
Status: A pull down menu that indicates the receiver's status (enabled or disabled) and allows the
administrator/user to perform actions on this user entry:
Enable: send traps to the receiver.
Disable: do not send traps to the receiver.
Secure Level: The authentication and encryption level for snmpv3.
None – no authentication checksum and no encryption algorithm assigned.
Auth – md5 or sha authentication checksum assigned and no encryption algorithm
assigned.
Priv – md5 or sha authentication checksum and des encryption algorithm assigned.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
234/1523