UANTA COMPUTER INC.
6.3.12 DHCPv6 Client Commands
6.3.12.1 ipv6 address dhcp
This command specifies the network of IPv6 configuration protocol to be used . If you modify this value,
the change is effective immediately.
Syntax
ipv6 address dhcp [restart]
<dhcp> - Obtains IPv6 address from DHCPv6.
<restart> - To restart the DHCPv6 process.
Default Setting
None
Command Mode
Interface-Vlan Config
Interface Config
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
247/1523