Service Port Commands - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

6.3.15 Service Port Commands

6.3.15.1 show serviceport
This command displays service port configuration information.
Syntax
show serviceport
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface Status: Indicates whether the interface is up or down.
IP Address: The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask: The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway:The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative Mode: Whether enabled or disabled. Default value is enabled.
IPv6 Prefix is: The IPv6 address and length. Default is Link Local format.
IPv6 Default Router: The default gateway address on the service port. The factory default value is
an unspecified address.Configured IPv4 Protocol: Indicate what IPv4 network protocol was used
on the last, or current power-up cycle, if any.
Configured IPv6 Protocol: Indicate what IPv6 network protocol was used on the last, or current
power-up cycle, if any.
IPv6 AutoConfig Mode: Whether enabled or disabled. Default value is disabled.
IPv6 Link-local Scope ID: The scope ID for this interface
Burned In MAC Address: The burned in MAC address used for in-band connectivity.
_____________________________________________________________________________
LB9 User's Guide
Layer 2/3/4 Managed Switch
261/1523