Quick Start Up User Account Management - Quanta Computer T5016-LB8D Use Manual

UANTA COMPUTER INC.

2.5.3 Quick Start up User Account Management

Table 2-3. Quick Start up User Account Management
Command
show users
show loginsession
username <username> {passwd |
nopasswd}
copy running-config startup-config
[filename]
_____________________________________________________________________________
LB9 User's Guide
Details
Displays all users that are allowed to access the switch
User Access Mode - Shows whether the user is able to change
parameters on the switch (Read/Write) or is only able to view
(Read Only).
As a factory default, admin has Read/Write access and guest
has Read Only access. There can only be one Read/Write user
and up to 5 Read Only users.
Displays all login session information
Allows the user to set passwords or change passwords needed
to login
A prompt will appear after the command is entered requesting
the old password. In the absence of an old password leave the
area blank. The operator must press enter to execute the
command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password and
the confirmed password match a message will be displayed.
The user password should not be more than eight characters in
length.
This will save passwords and all other changes to the device.
If you do not save config, all configurations will be lost when a
power cycle is performed on the switch or when the switch is
reset.
Layer 2/3/4 Managed Switch
25/1523