9 ] Switch Back To Standby; 10 ] Replace The Ink Cartridges With The Protective Part - Brother DCP130C Service Manual

[ 9 ] Switch back to standby

After completion of the adjustment, disconnect the USB cable and then enter 9 twice using the /
and OK keys to return to the standby state.
NOTE: Be sure to disconnect the USB cable first. Returning to standby without disconnecting the
USB cable runs "Found New Hardware Wizard" that starts USB driver installation (as described in
Section 7.1.2).
NOTE: Enable the initial setup mode (see

[ 10 ] Replace the ink cartridges with the protective part

Remove all four ink cartridges and set the protective part instead.
Chapter 9, Section
Ink cartridge cover
Protective part
7-24
9.4.13).
Ink cartridges
Confidential