ADF parts
(21) Place the document cover upside down.
(22) Remove the ADF pull-in piece and its spring from the document cover.
(23) Remove the separation pad from the document cover.
ADF pull-in spring
Assembling Notes
• When mounting the ADF pull-in piece on the document cover, be sure to set the ADF pull-in
spring as shown above.
• Before mounting the document roller holder onto the ADF unit (see
specified lubricant to the specified points, referring to
• When mounting the ADF motor onto the ADF unit, route the ADF motor harness and the
grounding wire as shown on
secure the grounding wire also with one of those screws (see
ADF pull-in piece
Separation pad
page
ADF pull-in spring
ADF pull-in piece
Section
6-18. When securing the motor with two screws, be sure to
6-21
Document cover
(placed upside down)
(Rear)
(6_22)
page
6-20), apply the
6.2.
page
6-18).
Confidential