2 ] Clean The New Head/Carriage Unit (Function Code 76); 3 ] Print Out A Test Pattern (Function Code 09) - Brother DCP130C Service Manual

[ 2 ] Clean the new head/carriage unit (Function code 76)

(1) Open the ink cartridge cover, set new ink cartridges into the ink refill ASSY, and close the ink
cartridge cover.
(2) Carry out "Initial purge" (with function code 76) using the steps below. (See
9.4.20.)
Enter 7 and 6 using the / and OK keys.
The machine displays "CLEANING ALL" on the LCD and enters the purge mode.
Enter 4 using the / and OK keys.
The machine starts an initial purge that refills the ink supply tubes and the new print head with
fresh ink.

[ 3 ] Print out a test pattern (Function code 09)

To check that the head/carriage unit normally sprays ink droplets from all head nozzles, print out a
test pattern with function code 09 (see
(1) Enter 0 and 9 using the / and OK keys.
(2) If a missing dot or any other print problem is found, go back to [ 2 ] above to clean the
head/carriage unit again.
Chapter 9, Section 9.4.4) with the following steps.
Test Pattern
7-9
Chapter 9, Section
Confidential