Travel Check Of The Head/Carriage Unit And Initial Setup Mode (Function Code 63) - Brother DCP130C Service Manual

9.4.13 Travel Check of the Head/Carriage Unit and Initial Setup Mode (Function code 63)

Function
This procedure moves the head/carriage unit to the center of its travel (Function code 63 + *).
It can also enable or disable the initial setup mode when the power is applied at the next time
(Function code 63 + 1 or Function code 63 +3).
Operating Procedure
(1) Enter 6 and 3 in the initial stage of the maintenance mode using the / and OK keys.
The "MAINTENANCE 63" appears on the LCD.
(2) To move the head/carriage unit to the center of its travel, enter * using the / and OK keys.
After completion of head replacement or adjustment jobs, press the Stop/Exit key. The
head/carriage unit returns to the home position where the head/carriage unit will be locked.
(3) To enable or disable the initial setup mode when the power is applied at the next time, enter 1
or 3, respectively, using the / and OK keys.
If you enable the initial setup mode, wait until the "INIT" appears on the LCD and the
head/carriage unit becomes locked. When the "HEAD LOCKED" appears, turn the power off.
NOTE: Enabling the initial setup mode resets all counts which can be displayed with Function
code 80 (described in
If you disable the initial setup mode, the machine displays the "NOT INIT" on the LCD and
returns to the initial stage of the maintenance mode.
Section 9.4.21 "Display of the Equipment's
9 - 2 6
Log").
Confidential