Brother DCP130C Service Manual page 102

Error Code
(Hex)
88 Recording paper jam.
(Even after paper pulling-in
operation, the registration
sensor is still OFF.)
89 Not used.
8A The paper feed motor does
not rotate.
Symptom
Jam clear cover not set
correctly
Paper feed motor harness
not connected correctly
Abnormal load applied to
the paper feed roller
PF-related gear(s) broken
PF encoder disk stained
or scratched
PF encoder sensor
defective
Main PCB defective
Paper feed motor
defective
4 - 1 2
Probable Cause
Recording paper not
loaded correctly
Registration sensor
defective
Bank ASSY deformed
Paper pull-in roller
holder defective
Mode switching lever
(at the right end of CR
guide rail) not sliding
smoothly
At the ends of the paper
feed roller shaft, any
gear(s) damaged
Main PCB defective
Paper feed motor
defective
Solution
Instruct the user to load
the recording paper
correctly.
Set the jam clear cover
into place.
Replace the registration
sensor PCB.
Replace the bank ASSY.
Replace the paper pull-
in roller holder.
Clean the mode switching
lever.
Replace the engine unit.
Replace the main PCB.
Replace the paper feed
motor.
Reconnect the paper feed
motor harness.
Replace the PF-related
gear(s).
Replace the PF encoder
disk.
Replace the PF encoder
PCB.
Replace the main PCB.
Replace the paper feed
motor.
Confidential