Brother DCP130C Service Manual page 207

CR guide rail and CR support chassis
Apply a 1.5 mm diameter ball of grease (Molykote EM-60L) to the 26 lubrication points below.
Lubrication procedure
(1) Move the head/carriage unit to the right end of its travel and hit it against the stoppers provided
at the right end of the CR guide rail and support chassis. This is to make the pair of slider cams
protrude to the left from the head/carriage unit, raising the head/carriage unit to the highest
position.
(2) Move the head/carriage unit close to the left end of its travel, taking care not to hit the slider
cams against the left stoppers to prevent the slider cams from protruding to the right.
(3) Apply grease to the 24 lubrication points on the CR guide rail and support chassis as specified
below.
As for the leftmost two lubrication points, apply grease after moving the head/carriage unit to
the right and out of those points.
(4) Move the head/carriage unit from the left to the right ends of its travel to spread the applied
grease on the CR guide rail and chassis.
To apply grease to this
leftmost point, move the
head/carriage unit to the right.
To apply grease to this
leftmost point, move the
head/carriage unit to the
right.
Apply grease to
these 13 points.
Apply grease to
CR support chassis
these 13 points.
6-74
CR guide rail
20 60
(6_76)
Confidential