Eeprom Customizing (Function Code 74) - Brother DCP130C Service Manual

9.4.18 EEPROM Customizing (Function code 74)

The "EEPROM Customizing Codes List" is given on the next page.
Function
This function allows you to customize the EEPROM according to language, function settings, and
firmware switch settings.
NOTE: If you replace the main PCB, be sure to carry out this procedure.
Operating Procedure
(1) Enter 7 and 4 in the initial stage of the maintenance mode using the / and OK keys.
The current customizing code appears on the LCD.
(2) Enter the desired customizing code using the / and OK keys.
Letters "A" through "F" can also be entered using the / and OK keys.
The newly entered code appears.
NOTE: If a wrong 4-digit code is entered, the machine will malfunction.
(3) Press the Black Start (Mono Start) key.
The machine saves the setting and returns to the initial stage of the maintenance mode.
If you press the Stop/Exit key or no keys are pressed for one minute in the above procedure,
the machine stops the procedure and returns to the initial stage of the maintenance mode.
9 - 3 4
Confidential