Assembling Notes
• Before mounting the main PCB, check that the thermal conductor rubber is set on the main PCB
shield frame. If it has come off, attach it to the main PCB shield frame so that it becomes aligned
with the L-shaped boss on the shield frame as shown on the previous page.
• When replacing the main PCB, check that the thermal conductor rubber is on the main PCB
shield frame, not on the bottom of the main PCB. Take care not to remove the old PCB with the
conductor rubber being attached.
• If you replace the main PCB, also replace the ink absorber box and flushing box. Otherwise,
drained ink may overflow after long-term use.
• If you replace the main PCB, you need to make the specified adjustments and updating of
settings stored in the flash ROM, referring to
that the head/carriage unit is mounted.
Chapter 7, Section
6-36
7.3. Before starting, make sure
Confidential