Brother DCP130C Service Manual page 371

Selector
No.
1
| PictBridge command delay time
2
Extension of the "No. of CNG cycles
to be detected" for Easy Receive
3
mode
(Not used.)
Recovery of cordless handset ID
4
(Not used.)
5
Caller ID tone alert detection period
(Not used.)
6
Transmission of caller ID wetting
pulse
7
(Not used.)
Switching between DTMF and FSK
for caller ID
8
(Not used.)
NOTE: Selectors 1 and 2 are applicable to PictBridge-enabled models.
NOTE: Selector 4 is applicable to models with cordless handset.
NOTE: Selectors 5 through 7 are applicable to the UK models.
NOTE: Selector 8 is applicable to the Chinese models.
Selectors 1 and 2:
These selectors specify the PictBridge command delay time that applies when the machine responds
to the digital camera connected via PictBridge during negotiation. If the machine fails to receive data
from the digital camera, change the delay time.
Selector 3: Extension of the "No. of CNG cycles to be detected" for Easy Receive mode (Not used.)
In Easy Receive mode, if the machine fails to detect the CNG even after the setting made by selectors
4 and 5 on WSW26, extend the "No. of CNG cycles to be detected" by two cycles.
Selector 4: Recovery of cordless handset ID (Not used.)
Enabling this function automatically writes the cordless handset ID registered on the main PCB onto
the cordless PCB when the power is turned on if the ID on the cordless PCB is discrepant with the
one on the main PCB.
WSW54
(Function setting 19)
Function
PictBridge command delay time
App. 4-58
Setting and Specifications
No. 1 2
0 0 : 100 ms (default)
0 1 : 0 ms
1 0 : 50 ms
1 1 : 200 ms
0: No 1: + 2 cycles
0: Enable 1: Disable
No. 5 6
0 0 : 10 ms (default)
0 1 : 20 ms
1 0 : 30 ms
1 1 : 40 ms
0: Enable 1: Disable
(default)
0: DTMF 1: FSK
(default)
ms: millisecond(s)
Confidential