Ink Absorber Box, Ink Absorber Felt, And Pf Encoder Disk - Brother DCP130C Service Manual

6.1.12 Ink Absorber Box, Ink Absorber Felt, and PF Encoder Disk

NOTE: Do not remove the ink absorber box unless it needs to be replaced.
NOTE: Once the two tubes (main drain tube and opening tube to the atmospheric air) are removed
from the ink absorber box for the replacement of the ink absorber box, they will become unusable
and new parts will have to be put back in. Using the removed tubes again may result in an ink
leakage.
(1) Pull out the two tubes (main drain tube and opening tube to the atmospheric air) from the ink
absorber box.
NOTE: Pinch the end of the main drain tube with a clip and wrap the end of the opening tube
to the atmospheric air in tissue paper in order to prevent drained ink from leaking and the
machine from getting stained with leaked ink.
(2) Pull the ink absorber box up and out of the lower cover.
(3) Immediately set a new ink absorber box. Then replace these two tubes; that is, pull them off
their joints on the maintenance unit and connect new tubes to the joints and new ink absorber
box as shown below.
NOTE: If the ink absorber box or its surroundings are stained with ink, wipe them off with a
cloth.
(4) Take the ink absorber felt out of the lower cover.
Viewed from the right
Opening tube to the
atmospheric air
Main drain tube
Maintenance unit
Pull down the main drain tube from this
joint and immediately connect a new one
to this.
Pull up the opening tube to the atmospheric
air from this joint and immediately connect
a new one to this.
Ink absorber box
Ink absorber felt
Lower cover
6-52
(6_51)
Confidential