Brother DCP130C Service Manual page 368

Selector
No.
Output of communications error
1 report when transmission
verification report is disabled
CR motor control for reducing
2
torque fluctuation
3
Cordless handset transmitter volume
4
5
Transmitter level and echo
|
suppression
7
Switching from ink near-empty to
8 ink empty when opening the scanner
cover
NOTE: Selectors 3 and 4 are applicable to models equipped with cordless handset.
Selector 2: CR motor control for reducing torque fluctuation
When the CR motor runs, the motor torque may vary so as to cause the head/carriage unit travel
velocity to fluctuate, affecting the print quality. Setting this selector to "0" activates the CR motor
control that regulates the motor drive current to reduce torque fluctuation, running the CR motor
smoothly.
Selectors 5 through 7: Transmitter level and echo suppression
Transmitter level 0 sets the transmitter volume to a maximum. As the level increases, the volume
decreases. The transmitter level can also be changed by the user switch and its setting is interlocked
with the setting made by these selectors.
Enabling the echo suppression suppresses echoes in both the receiver and transmitter.
Selector 8: Switching from ink near-empty to ink empty when opening the scanner cover
If this selector is set to "0," opening the scanner cover switches from ink near-empty (if detected) to
ink empty state, prompting the user to replace the near-empty ink cartridge(s) immediately.
WSW51
(Function setting 16) (Not used.)
Function
App. 4-55
Setting and Specifications
0: Enable 1: Disable
0: Activate 1: Deactivate
No. 3 4
0 0 : Middle (default)
0 1 : Low
1 0 : High
1 1 : Very high
No. 5 6 7
0 0 0 : Transmitter level 0 &
echo suppression OFF
0 0 1 : Transmitter level 1 &
echo suppression ON
0 1 0 : Transmitter level 2 &
echo suppression ON
0 1 1 : Transmitter level 3 &
echo suppression ON
0: Yes 1: No
(No change from ink near-
empty)
Confidential