Brother DCP130C Service Manual page 183

Routing the Head Flat Cables When Mounting the Carriage PCB ASSY
1) Set the FFC support on the head flat cables.
- Fit the loop of the head flat cables over the small boss inside the FFC support as shown below.
FFC support
2) Mount the carriage PCB on the head/carriage unit (see
3) Latch the FFC support onto the head/carriage unit (see
4) Route the head flat cables through the cable guides
and pass them through the flat core and the opening
provided in the lower cover.
Boss
Cable guides
(Rear)
Cable guides
Carriage PCB
Small boss
Loop
Head flat cable 1
Opening
Head flat cable 2
Head flat cable 3
Flat core
Carriage motor harness
Head flat
cables
page 6-43).
page 6-43).
5) Set the tube support wire and spring onto the
flat cable support plate. Fit the bent end of the
spring on the tube/cable guide as shown below,
turn the spring clockwise once and hook it on
the tube support wire so that the spring pulls the
wire to the front.
Then, mount the flat cable support plate so that
the head flat cables (and ink supply tubes) pass
between the tube/cable guide on the support
plate and the lower cover.
(6_44_2)
(Rear)
Spring
Hook
Flat cable support plate
6-50
(6_44_1)
Tube/cable guide
Lower cover
Tube support wire
Confidential
(6_44_3)