Charging Battery Packs; Power Cord; Versatile Hanger - Tektronix TPS2000 Series User Manual

Getting Started
To remove the battery packs, follow these steps:
1. Press the battery compartment door latch on the the right side
panel and open the battery compartment.
2. Grab the strap and lift up.
3. Push the spring clip towards the outside of the battery pack and
pull the strap to remove the battery pack.
4. Close the battery compartment door.

Charging Battery Packs

You can charge the battery packs in an oscilloscope or with the
TPSCHG external battery charger. See page 8- - 6.

Power Cord

Use only power cords designed for the AC adaptor for the oscillo-
scope or external charger. The AC adaptor for the oscilloscope and
external charger requires 90 to 264 VAC
page B- - 2 for a list of available power cords.

Versatile Hanger

Use the versatile hanger to securely suspend the oscilloscope when
you cannot place it on a stable surface, such as on a bench top.
1- 10
TPS2000 Series Digital Oscilloscope User Manual
, 45 to 66 Hz. Refer to
RMS