Tektronix TPS2000 Series User Manual page 145

4. Power on the oscilloscope.
5. Push the UTILITY button to see the Utility Menu.
6. Push Options
7. Check that the menu settings match those listed in the table on
page 6- - 8.
8. From your PC terminal program, type ID?, then press the Return
or Enter key to send the command. The oscilloscope sends back
its identification string, which should look similar to the
following:
ID TEK/TPS 2024,CF:91.1CT,FV:V10.00
NOTE. For brief information on command entry, refer to page 6- - 13.
For complete command information, refer to the TDS200, TDS1000,
TDS2000, and TPS2000 Series Digital Oscilloscopes Programmer
Manual.
RS-232 Troubleshooting
If the oscilloscope and the external device (computer or printer) have
trouble communicating, follow these steps:
1. Check that you are using the correct RS-232 cable. Determine
whether your external device requires a null-modem or a
straight-through connection. Refer to the table on page 6- - 6 for
information about RS-232 cables.
TPS2000 Series Digital Oscilloscope User Manual
Communications (RS-232 and Centronics)
RS-232 Setup.
6- 9