General Safety Summary - Tektronix TPS2000 Series User Manual

General Safety Summary

Review the following safety precautions to avoid injury and prevent
damage to this product or any products connected to it.
To avoid potential hazards, use this product only as specified.
Only qualified personnel should perform service procedures.
To Avoid Fire or Personal Injury
Use Proper Power Cord. Use only the power cord specified for this
product and certified for the country of use.
Connect and Disconnect Properly. Do not connect or disconnect probes
or test leads while they are connected to a voltage source.
Connect and Disconnect Properly. Connect the probe output to the
measurement instrument before connecting the probe to the circuit
under test. Disconnect the probe input and the probe reference lead
from the circuit under test before disconnecting the probe from the
measurement instrument.
Observe All Terminal Ratings. To avoid fire or shock hazard, observe all
ratings and markings on the product. Consult the product manual for
further ratings information before making connections to the product.
Use Proper Probe. To avoid shock hazard, use a properly rated probe
for your measurement.
Floating. Do not float the P2220 probe reference lead to > 30 V
Use the P5120 (floatable to 600 V
III) or similarly rated, passive, high voltage probe or an appropriately
rated, high voltage differential probe when floating the reference
lead above 30 V
probe.
Powering Off. The power cord provides Mains disconnect.
Replace Batteries Properly. Replace batteries only with the proper type
and rating specified.
Recharge Batteries Properly. Recharge batteries for the recommended
charge cycle only.
TPS2000 Series Digital Oscilloscope User Manual
, subject to the ratings of such high voltage
RMS
CAT II or 300 V
RMS
.
RMS
CAT
RMS
vii