Port Grouping; Port Grouping Overview; Figure 130 Network > Interface > Edit > Add Static Dhcp - ZyXEL Communications ZyWALL 1050 User Manual

ZyWALL 1050 User's Guide
Table 49 Network > Interface > Ethernet > Edit (continued)
LABEL
Add Static DHCP Click this if you want the ZyWALL to assign static IP addresses to computers.
Ping Check
Enable
Check Period
Check Timeout
Check Fail
Tolerance
Ping Default
Gateway
Ping this address Select this to ping a specified domain name or IP address. Enter that domain

10.3 Port Grouping

This section introduces port groups and then explains the screen for port groups.

10.3.1 Port Grouping Overview

Use port grouping to create port groups and to assign physical ports and port groups to
Ethernet interfaces.
190
DESCRIPTION
The Static DHCP screen appears.
Figure 130 Network > Interface > Edit > Add Static DHCP
The ZyWALL checks this table when it assigns IP addresses. If the computer's
MAC address is in the table, the ZyWALL assigns the corresponding IP address.
Otherwise, the ZyWALL assigns the IP address dynamically using the IP Pool
Start Address and Pool Size.
Note: You must click OK in the Static DHCP screen and then
click OK in this screen to save your changes.
The interface can regularly ping the gateway you specified to make sure it is still
available. You specify how often the interface pings the gateway, how long to
wait for a response before the attempt is a failure, and how many consecutive
failures are required before the ZyWALL stops routing to the gateway. The
ZyWALL resumes routing to the gateway the first time the gateway
acknowledges the ping.
Select this to enable the ping check.
Enter the number of seconds between ping attempts.
Enter the number of seconds to wait for a response before the attempt is a
failure.
Enter the number of consecutive failures before the ZyWALL stops routing
through the gateway.
Select this to ping the default gateway.
name or IP address in the field next to it.
Chapter 10 Interface