Figure 56 Network > Interface > Trunk > Add, Member Ge3; Figure 57 Network > Interface > Trunk > Add, Final; Figure 58 Network > Interface > Trunk, Final - ZyXEL Communications ZyWALL 1050 User Manual

ZyWALL 1050 User's Guide
Figure 56 Network > Interface > Trunk > add, Member ge3
6 Click the Add icon for ge3, as shown above, and repeat steps
then appears as shown below.
Figure 57 Network > Interface > Trunk > add, Final
7 Use the default values for the rest of the settings. Click OK to save these changes and
return to the previous screen.
Figure 58 Network > Interface > Trunk, Final
8 Next, set up a policy route for the trunk. Click Policy > Route > Policy Route, and click
the Add icon.
9 Change the Incoming field to ge1. By default, there is an address object called
LAN_SUBNET with the same settings as ge1 (192.168.1.0/24). Select it in the Source
Address field. In the Next-Hop section, select Trunk, and then select WAN_TRUNK.
Finally, select outgoing-interface in the Source Network Address Translation field to
set up NAT, and click OK.
126
4-5 to add ge4. The screen
Chapter 6 Tutorials