Pppoe/Pptp Interface Summary; Figure 143 Network > Interface > Pppoe/Pptp; Table 58 Network > Interface > Pppoe/Pptp - ZyXEL Communications ZyWALL 1050 User Manual

ZyWALL 1050 User's Guide
2 You do not set up the subnet mask or gateway.
PPPoE/PPTP interfaces are interfaces between the ZyWALL and only one computer.
Therefore, the subnet mask is always 255.255.255.255. In addition, the ZyWALL always
treats the ISP as a gateway.
At the time of writing, it is possible to set up the IP address of the gateway (ISP) using CLI
commands but not in the web configurator.

10.6.3 PPPoE/PPTP Interface Summary

Note: You have to set up an ISP account before you create a PPPoE/PPTP interface.
This screen lists every PPPoE/PPTP interface. To access this screen, click Network >
Interface > PPPoE/PPTP.
Figure 143 Network > Interface > PPPoE/PPTP
Each field is described in the table below.
Table 58 Network > Interface > PPPoE/PPTP
LABEL
#
Name
Base Interface
Account Profile
Add icon
208
DESCRIPTION
This field is a sequential value, and it is not associated with any interface.
This field displays the name of the interface.
This field displays the interface on the top of which the PPPoE/PPTP interface
is.
This field displays the ISP account used by this PPPoE/PPTP interface.
This column lets you create, edit, remove, activate, deactivate, connect and
disconnect interfaces.
To create an interface, click the Add icon at the top of the column. The PPPoE/
PPTP Interface Add/Edit screen appears.
To edit an interface, click the Edit icon next to it. The PPPoE/PPTP Interface
Add/Edit screen appears.
To remove an interface, click the Remove icon next to it. The ZyWALL confirms
you want to remove it before doing so.
To activate or deactivate an interface, click the Active icon next to it.
To connect or disconnect an interface, click the Connect icon next to it. You
might use this icon to test the interface or to manually establish the connection
for a Dial-on-Demand PPPoE/PPTP interface.
Chapter 10 Interface