Log Settings Screens - ZyXEL Communications ZyWALL 1050 User Manual

Table 185 Maintenance > Logs > View Log (continued)
LABEL
Priority
Source
Address
Destination
Address
Service
Keyword
Search
entries per page
#
Time
Priority
Category
Message
Source
Destination
Note
The Web configurator saves the filter settings if you leave the View Log screen and return to it
later.

36.2 Log Settings Screens

The Log Settings screens control log messages and alerts. A log message stores the
information for viewing (for example, in the View Log tab) or regular e-mailing later, and an
alert is e-mailed immediately. Usually, alerts are used for events that require more serious
attention, such as system errors and attacks.
Chapter 36 Logs
DESCRIPTION
This field is read-only if the Category is Debug Log. Select the lowest-priority log
messages you would like to see. The log will display every log message with this
priority or higher. Choices are: emerg, alert, crit, error, warn, notice, and info,
from highest priority to lowest priority.
Type the IP address of the source of the incoming packet when the log message
was generated. Do not include the port in this filter.
Type the IP address of the destination of the incoming packet when the log
message was generated. Do not include the port in this filter.
Select the service whose log messages you would like to see. The web configurator
uses the protocol and destination port number(s) of the service to select which log
messages you see.
Type a keyword to look for in the Message, Source, Destination and Note fields. If
a match is found in any field, the log message is displayed. You can use up to 63
alphanumeric characters and the underscore, as well as punctuation marks ()' ,:;?!
+-*/= #$% @ ; the period, double quotes, and brackets are not allowed.
Click this button to update the log using the current filter settings.
Select the number of log messages you would like to see on one screen. Choices
are: 30, 50, and 80.
This field is a sequential value, and it is not associated with a specific log message.
This field displays the time the log message was recorded.
This field displays the priority of the log message. It has the same range of values
as the Priority field above.
This field displays the log that generated the log message. It is the same value used
in the Display and (other) Category fields.
This field displays the reason the log message was generated. The text "[count=x]",
where x is a number, appears at the end of the Message field if log consolidation is
turned on (see Log Consolidation in
were aggregated to generate into this one.
This field displays the source IP address and the port number in the event that
generated the log message.
This field displays the destination IP address and the port number of the event that
generated the log message.
This field displays any additional information about the log message.
ZyWALL 1050 User's Guide
Table 187 on page 531) and multiple entries
527