Set Up The Password For Synchronization; Finish Configuring The Master; Figure 82 Status > Interface Status Summary; Figure 83 Network > Device Ha > Vrrp Group > Add - ZyXEL Communications ZyWALL 1050 User Manual

Figure 82 Status > Interface Status Summary
4 Repeat these steps for the interface that is connected to the Internet. The second VRRP
group should have a different VR ID. Part of an example using ge3 is shown below.
Figure 83 Network > Device HA > VRRP Group > add
Note: Once you configure an interface in a VRRP group, you should not configure the
interface to have a dynamic IP address.

6.3.4 Set up the Password for Synchronization

1 Click Network > Device HA > Synchronize.
2 Type the password for synchronization in the Password field. This password does not
have to be the same as the password for the admin account, but you have to set the same
password in the master and backup. Click Apply.
Figure 84 Network > Device HA > Synchronize

6.3.5 Finish Configuring the Master

Finish configuring the master. The backup router will get these updates later, when it
synchronizes with the master.
Chapter 6 Tutorials
ZyWALL 1050 User's Guide
139