Zone Add/Edit; Figure 179 Configuration > Network > Zone > Edit; Table 81 Configuration > Network > Zone > Edit - ZyXEL Communications ZyWALL 1050 User Manual

14.3 Zone Add/Edit

The Zone Add/Edit screen allows you to define a zone or edit an existing one. To access this
screen, go to the Zone screen (see
an Edit icon.
Figure 179 Configuration > Network > Zone > Edit
The following table describes the labels in this screen.
Table 81 Configuration > Network > Zone > Edit
LABEL
Name
Block Intra-zone
Traffic
#
Member
Add icon
Chapter 14 Zones
Section 14.2 on page
DESCRIPTION
Type the name used to refer to the zone. You may use 1-31 alphanumeric
characters, underscores( _
number. This value is case-sensitive.
Select this check box to block network traffic between members in the zone.
This field is a sequential value, and it is not associated with a specific member of
the zone.
This field displays the name of each member in the zone. The word in front of the
name indicates whether this member is an interface or a VPN tunnel.
IFACE - this member is an interface.
IPSEC - this member is a VPN tunnel.
Click the icon next to each member to change the member. You can only add
interfaces and VPN tunnels that are not assigned to a zone, however.
This column provides icons to add members to and remove members from the
zone.
To add a member to the zone, click the Add icon at the top of the column to add the
new member at the beginning of the list, or click the Add icon next to an existing
member to add the new member after the existing one. The web configurator
chooses a new member alphabetically. You can use the Popup icon next to the
member to change this choice.
To remove a member from the zone, click the Remove icon next to the member.
The web configurator confirms that you want to remove the member.
268), and click either the Add icon or
), or dashes (-), but the first character cannot be a
ZyWALL 1050 User's Guide
269