Chapter 38 Reboot; Figure 353 Maintenance > Reboot - ZyXEL Communications ZyWALL 1050 User Manual

Hide thumbs Also See for ZyWALL 1050:

Table of Contents

ZyWALL 1050 User's Guide

Use this to restart the device (for example, if the device begins behaving erratically). See also

Section 1.4 on page 50

for information on different ways to start and stop the ZyWALL.

If you applied changes in the Web configurator, these were saved automatically and do not

change when you reboot. If you made changes in the CLI, however, you have to use the

command to save the configuration before you reboot. Otherwise, the changes are lost

when you reboot.

Reboot is different to reset; (see

Section 1.5 on page

50) reset returns the device to its default

configuration.

The Reboot screen is part of the Web configurator so that remote users can restart the device.

To access this screen, click Maintenance > Reboot.

Figure 353 Maintenance > Reboot

Click the Reboot button to restart the device. Wait a few minutes until the login screen

appears. If the login screen does not appear, type the IP address of the device in your Web

You can also use the CLI command

to restart the device.

Chapter 38 Reboot