Copy - Copying The Currently Selected Model To Another Model Memory - JR X9303 2.4 Instruction And Programming Manual

Copy – Copying the Currently Selected Model to Another Model Memory
The Copy function is part of the Model SEL function
and allows the contents of the current model memory
to be copied into another model memory in the same
transmitter. It is not used to transfer the model to another
transmitter or to a Data Safe unit – the DATA TRANSFER
function provides for these activities.
The Copy function is valuable because it can provide
some insurance against losing programs (helicopter
setups) that may have been very time-consuming to
create. It is strongly recommended that the Copy function
be used to make a backup copy of the model memory
for safe keeping after programming for a model has been
completed, tested and refined.
The display shows the currently selected model on top
with a down arrow pointing to the lower model memory
that the current model will be copied into. The data that
is presently in the lower model memory will be entirely
replaced by the data in the currently selected model, so be
sure that the lower model is either empty or contains data
that is no longer required.
[Model SEL]
Copy
MODEL 3 HELI
MODEL 4 HELI
COPY
[Model SEL]
Copy
MODEL 3 HELI
MODEL 4
COPY
Making a backup copy of the model memory protects
against losing the original program and also allows one
to experiment with the original program, knowing that the
original settings can be restored by copying the backup
copy back to the original model memory.
1. The model to be copied must be currently selected
– see Model SEL description at the beginning of the
HELI section.
2. Highlight and select Model SEL in the SYSTEM Menu.
Highlight and select Select to obtain the Copy display.
HELI
H-3