JR X9303 2.4 Instruction And Programming Manual page 165

MULTI-POINT PROGRAMMABLE MIXER (continued)
Curve/Line - (Multi-Point Mixer)
The Curve/Line is the line that results from connecting all
of the points together based upon their point values.
Graph - (Multi-Point Mixer)
The graph illustrates the mixing curve. The X-Axis
(horizontal plane) represents Master channel movement.
The Y-Axis (vertical plane) represents the Slave servo
movement where the bottom 1/2 of the graph is one
direction from neutral and the top portion of the graph is
the other direction.
Points That Can Be Adjusted - (Multi-Point Mixer)
The points that can be adjusted are listed vertically by
name and are also displayed by number along the bottom
of the graph. Use the numbers along the bottom of the
graph to determine which point(s) need adjustment.
Change the value of a point by highlighting and selecting
the Point Name and dialing-in the desired percentage.
Exponential - (Multi-Point Mixer)
This parameter smoothes the Curve/Line between all of
the points on the graph to provide a smoother mixing
response. The default value is
smooth the mixing curve, highlight and select
will toggle to .
ON
Slave Channel Position - (Multi-Point Mixer)
The Slave servo position next to OUT at the bottom left of
the display is expressed in values from -100 to +100, with
0 being neutral or center. It represents the servo travel that
corresponds to the present Master Channel position.
Note: When the mixer is switched OFF, the out
value will change to OFF instead of displaying the
Slave position. This is how to determine if the
mixer is ON or OFF.
Master Channel Position - (Multi-Point Mixer)
The Master channel position is shown on the bottom line
of the display next to IN and is expressed in values from
0 to 100 with 50 being the center or neutral position. It
represents the present Master channel position.
. To turn it on and
OFF
and it
OFF
Select Switch - (Multi-Point Mixer)
There are 3 switches that can be always used to switch
between the Pos0 and Pos1 settings (if the upper and
lower settings for Pos0 or Pos1 are left at 0% the mixer
can be turned on and off with the switch). They include
the Rudder D/R switch, Butterfly Switch, Rudder D/R
switch and the AUX4 switch. In addition, if Flight Modes
are activated in the Devic.SEL function, then 5 more
switches may be selected: Cruise, Speed, Thermal,
Launch and Land, which correspond to the 3 positions of
the Flight Mode switch.
To select a switch that will switch between the Pos0 and
Pos1 values, highlight and select the switch name and
it will toggle between pos0 and pos1. Set the desired
switch(es) to pos1.
CLR Button - (Multi-Point Mixer)
Pressing the CLR button while a modifiable parameter is
selected will reset the parameter to its default value.
Note: Pressing the CLR button when either the
Master or Slave is highlighted Inhibits the entire
mixer and it is no longer functional.
LIST Button - (Multi-Point Mixer)
Press the LIST button to return to the FUNCTION List, or
rotate the rotary selector until
and select it to return to the SYSTEM Menu.
ENT Button - (Multi-Point Mixer)
Pressing the ENT button returns to the Main Display.
TO INHIBIT A MIXER (TURN IT OFF ENTIRELY)
Highlight either the Master or Slave and press the CLR
button to completely disable a mixer.
appears next to LIST
LST
S-35