Advanced Digital Trims; Control Stick Length; Neckstrap Attachment - JR X9303 2.4 Instruction And Programming Manual

Advanced Digital Trims

The X9303 2.4 features Advanced digital trims. On the
Normal display screen, if a trim lever is moved, the screen
will automatically change to display the graphic position
for the trim being adjusted. The X9303 2.4's Aileron,
Elevator, and Rudder trim levers feature an audible center
trim beep. This is helpful in determining the trim levers'
center position during flight. In addition, the frequency of
each trim step changes from full right/up to full left/down,
allowing the pilot to be aware of the general trim position
audibly without looking at the transmitter.

Control Stick Length

Use a 2mm Allen wrench to unlock the setscrew to adjust
the stick length. Turn the wrench counterclockwise to
loosen the screw. Then, turn the stick clockwise to shorten
or counterclockwise to lengthen the overall stick length.
After the control stick length has been adjusted to suit your
flying style, tighten the 2mm setscrew. If you desire longer
sticks, JR® offers a stick (JRPA047) that is approximately
one inch longer than standard, and has various length
anodized aluminum stick ends available (JRPA040-
JRPA045). These stick ends are crafted from bar stock
aluminum, and are available at your local JR dealer.

Neckstrap Attachment

An eyelet is provided on the face of the X9303 2.4 transmitter
that allows you to connect a Neck Strap (JRPA023).
G-16
By using the Trim Step Function located in the System
Mode, the amount of travel per each trim step can be
adjusted as needed to match your specific application.
Please note that when the X9303 2.4 transmitter is turned
off, the trim values are stored in memory and are recalled
when the system is turned back on.
SETSCREW
LOOSEN
TIGHTEN