Acro - Function List; Rev.sw - Servo Reversing; Sub Trim - JR X9303 2.4 Instruction And Programming Manual

ACRO – FUNCTION LIST
Once the basic aircraft configuration has been defined in
the SYSTEM Menu, the functions found in the Function
List [FUNC.LIST] are used to complete the setup and
then to adjust how the aircraft flies. The functions are
presented (to the extent practical) in the order that they
should be addressed when setting up a new aircraft.
REV.SW – SERVO REVERSING
Once all servos have been plugged into their proper
channels in the receiver, the first thing to check is the
direction of travel of each servo. Move all sticks and
switches/levers while observing each servo to determine
if the servos are moving in the correct directions. Make
note of those channels that are not traveling in the correct
direction and use the REV.SW function to reverse the
direction of travel for these channels.
[FUNC. LIST]
D/R & EXP FLAP SYS.
Snap Roll
REV. SW

Sub Trim

TRVL ADJ.
ELE FLP M
AIL RUD M SRV. Speed
THRO CURV
[REV SW.]
THR AIL ELE RUD
The descriptions are general in nature and are intended to
provide enough information to decide whether or not to
use a function and what types of selections and settings
to make.
Press the LIST button after the transmitter is powered-up
to obtain the FUNC.LIST.
Prog. Mix1 Trainer
Prog. Mix2 TIMER
Prog. Mix3 MONITOR
Prog. Mix4
Prog. Mix5
Prog. Mix6
1. Highlight and select REV.SW in the FUNC.LIST to
obtain the servo reversing display.
2. Use the Selector to highlight and select those
channels that need to be reversed. Pressing
the Selector toggles the channel between
Normal and Reverse.
REV.
NORM
GER FLP AX2 AX3 AX4
A-19