JR X9303 2.4 Instruction And Programming Manual page 161

PROG MIX - PROGRAMMABLE MIXERS (continued)
Slave Channel - (Std. Prog Mixer)
This is the Slave channel that will move according to the
program mix in relation to the Master channel. The default
for both the Master and the Slave channel is FPRN.
Current Switch Position - (Std. Prog Mixer)
Indicates the current switch position of the switch (if any)
that controls the mixer.
Direction - (Std. Prog Mixer)
Each standard programmable mixer has two positions
- Pos0 and Pos1 and each position has 2 percentages
(upper and lower) to accommodate mixing when the
Master is moved in both directions.
The direction indicator consists of a dotted and solid line
next to the switch position on the top line of the display.
The solid line indicates whether the upper or lower
percentage is in effect for either Pos0 or Pos1, depending
on which Position is currently selected.
As the Master channel is moved above and below the
Offset (where the mix turns on or changes direction), the
solid bar moves between the top and bottom line. If for
example, the switch is set so that Pos0 percentages are in
effect and the master channel is moved below the Offset,
the solid bar will be on the lower line which means the
lower percentage associated with Pos0 is in effect. When
the master is moved above the Offset, the solid bar moves
to the top line indicating that the upper percentage for
Pos0 is in effect.
The Direction Indicator works the same way when the
Pos1 values are selected, indicating the upper or lower
value of Pos1 as the Master is moved in both directions
from the Offset.
[PROG.Mix3]◊0
Pos0
FPRN≥FPRN
CRU LAU LND AX4 BTF RUD
POS1
POS0
The Slave channel is selected by highlighting and
selecting this parameter to obtain a list of channels and
then selecting the Slave channel from the list. The list
contains each of the 9 channels in the system.
0% Pos0 0%
0% 0%
Offset
Pos0 Settings - (Std. Prog Mixer)
Each standard Programmable mixer can have two sets
of mixing values -
Pos0
2 percentages which control movement of the slave
when the master is moved in both directions. A switch
can be selected to switch between the
percentages.
The settings determine how far, and in which
Pos0
direction, the slave channel moves when the master is
moved above and below the Offset (the Master moving in
both directions) when the switch is in a position to select
the Pos0 values.
To enter values, highlight and select
Pos0
the Master channel control (stick, lever or switch) in one
direction and set the percentage and then move the Master
channel control in the other direction and set its value.
Pos1 Settings - (Std. Prog Mixer)
The Pos1 settings are identical to the
and determine how far, and in which direction, the slave
channel moves when the master is moved above and
below the offset (the Master moving in both directions)
when the switch is in a position to select the Pos1 values.
To enter values, highlight and select
Pos1
the Master channel control (stick, lever or switch) in one
direction and set the percentage and then move the Master
channel control in the other direction and set its value.
0
and . Each set can have
Pos1
and
Pos0 Pos1
, move
Pos0
settings
Pos0
, move
Pos1
S-31