X9303 2.4 Transmitter Features (Internal; Control Stick Tension Adjustment; Back Of Transmitter (Mode 2 - JR X9303 2.4 Instruction And Programming Manual

X9303 2.4 Transmitter Features (Internal)

AILERON TENSION SCREW
ELEVATOR TENSION SCREW

Control Stick Tension Adjustment

Remove the six transmitter screws from the back cover as
shown on page G-14. Remove the transmitter back, being
careful not to cause damage to any components.
RUDDER TENSION SCREW

Back of Transmitter (Mode 2)

Adjust each gimbal tension screw for desired tension
(counter-clockwise to loosen stick tension; clockwise to
tighten stick tension). When adjusting the throttle ratchet
tension, make sure that the adjusting screw does not
touch the PC board after adjustment is complete.
THROTTLE TENSION SCREW
G-15