Switch Assignments; Flap Trim On/Off - JR X9303 2.4 Instruction And Programming Manual

SWITCH ASSIGNMENTS

The X9303 2.4 provides the ability to change the standard
default switch assignments for GEAR, FLAP, AUX2, AUX3,
and AUX4. The standard switch assignments may be
changed in the Devic.SEL function contained in the SYSTEM
Menu. To change one or more switch assignments:

FLAP TRIM ON/OFF

1. The digital FLAP TRIM lever is located next to the
FLAP switch. It may be activated or deactivated in
the Devic.SEL function by using the Selector to
highlight either ON or OFF and pressing the Selector
to toggle between these two values.
[Devic. SEL]
FLIGHT MODE
GEAR FLAP AUX2 AUX3 AUX4
INH
GEAR FLAP AUX2 AUX3 RUDD
AIL D/R
SW
ELE D/R
TRIM
RUD D/R
OUT: INH MIX SW
[Devic. SEL]
FLIGHT MODE
GEAR FLAP AUX2 AUX3 AUX4
FLAP SW
GEAR FLAP AUX2 AUX3 RUDD
SW
TRIM:FM
TRIM
D/R:FM
OUT: INH
1. From within the Devic.SEL function, use the Selector
to highlight and select GEAR, FLAP, AUX2, AUX3,
or AUX4 along the top line of the display.
2. Once a switch is selected, a list of available
replacement switches is displayed. Highlight and select
the desired switch with the Selector.
3. Repeat for as many switches as desired.
AUX2 SW
SW SW LEV D/R
FLAP SW
ON
GEAR SW
ACT SNAP SW ACT INH ACT
Ordinarily this switch should be turned OFF,
even if the aircraft has flaps or flaperons, because the
system provides other means of controlling flaps and
disabling this switch will help prevent a serious out-of-
trim condition if flaperons are used and the trim lever is
accidentally moved. Do not turn this on unless there
is a specific need to do so.
SW SW LEV D/R
OFF
ACT ACT INH ACT
A-9