JR X9303 2.4 Instruction And Programming Manual page 162

PROG MIX - PROGRAMMABLE MIXERS (continued)
Offset - (Std. Prog Mixer)
The parameter defines the position of the
Offset
Master where the mixer changes directions. The
automatically defaults to a channel's center position
or 0 (zero). For example, if the Rudder is the Master,
the will automatically default to the center stick
Offset
position (no rudder input). Since the
center, moving the rudder stick to the left of center causes
a mix in one direction while moving the rudder stick to
the right of center causes a mix in the other direction.
Directions correspond to the upper and lower percentages
for and the upper and lower percentages of
Pos0
The amount of mix and actual direction that the slave
moves is determined by the Pos0/Pos1 values. The Offset
applies to both Pos0 and Pos1 settings.
The Offset may be changed by highlighting and selecting
Offset and adjusting either a positive (+) or negative (-)
value. A positive percentage moves the offset in one
direction from center while a negative percentage moves
the Offset in the other direction from center.
S-32
Offset
is at the
Offset
.
Pos1
Available Switches - (Std. Prog Mixer)
There are 3 switches that can be always used to switch
between the Pos0 and Pos1 settings (if the upper and
lower settings for Pos0 or Pos1 are left at 0% the mixer
can be turned on and off with the switch). They include
the Rudder D/R switch, Butterfly Switch, Rudder D/R
switch and the AUX4 switch. In addition, if Flight Modes
are activated in the Devic.SEL function, then 5 more
switches may be selected: Cruise, Speed, Thermal,
Launch and Land, which correspond to the 3 positions of
the Flight Mode switch.
To select a switch that will alternate between the Pos0
and Pos1 values, highlight and select the switch name
and it will toggle between pos0 and pos1. Set the desired
switch(es) to pos1.
CLR Button - (Std. Prog Mixer)
Pressing the CLR button while a modifiable parameter is
selected will reset the parameter to its default value.
Note: Pressing the CLR button when either the
Master or Slave is highlighted Inhibits the entire
mixer and it is no longer functional.
LIST Button - (Std. Prog Mixer)
Press the LIST button to return to the FUNCTION List, or
rotate the rotary selector until
and select it to return to the SYSTEM Menu.
ENT Button - (Std. Prog Mixer)
Pressing the ENT button returns to the Main Display.
TO INHIBIT A MIXER (TURN IT OFF ENTIRELY)
Highlight either the Master or Slave and press the CLR
button to completely disable a mixer.
appears next to LIST
LST