Step #26 Aileron-To-Flap; Step #27 Aileron Differential - JR X9303 2.4 Instruction And Programming Manual

Step #26 Aileron-to-Flap

This function gives added roll response by mixing
ailerons to flaps such that the entire trailing edge
functions as an aileron. In
until is highlighted. Press the Selector to
AIL  FLP M
access the Aileron-to-flap mix. Rotate the Selector to
highlight then press the Selector selecting
CRU

Step #27 Aileron Differential

rotate the Selector until
In
FUNC.LIST
highlighted. Press the Selector to access the Aileron
differential menu. Rotate the Selector to highlight the
cruise aileron value then press the Selector to access
that value. With the flight mode switch in the middle
S-58
rotate the Selector
FUNC.LIST
Pos1
[AIL≥FLP M]◊0
Pos0: 0%
CRU LAU
POS1
POS0
DIFFEREN.
[DIFFEREN.]
◊ CRUISE
LAUNCH
LAND
This will apply the same vales as selected previously in
the launch mode to the cruise. If you choose a different
aileron-to-flap value, then select
value to achieve the desired results. Press the
Pos0
button to return to the Function Mode screen.
.
Pos1:+ 16%
LND AX4 BTF RUD
is cruise mode, give a full right aileron command and rotate
the Selector to achieve the desired aileron differential for
cruise. Pressing the Selector will store the value. Now
rotate the Selector to highlight the cruise flap value and
adjust it to the desired position. Press the LIST button to
return to the Function Mode screen.
AILE FLAP
+60% +40%
+50% +30%
+20% 0%
and adjust the
Pos0
LIST