Step #18 Aileron-to-Flap
This function gives added roll response by mixing
ailerons to flaps such that the entire trailing edge
functions as an aileron. In
until
is highlighted. Press the Selector to
AIL
FLP M
access the Aileron-to-flap mix. Rotate the Selector to
highlight
then press the Selector selecting
LND
Rotate the Selector to highlight Pos1 above and press
Step #19 Aileron Differential
In
rotate the Selector until
FUNC.LIST
highlighted. Press the Selector to access the Aileron
differential menu. Rotate the Selector to highlight the
launch aileron value then press the Selector to access
that value. With the flight mode switch in the upper launch
mode, give a full right aileron command and rotate the
S-52
rotate the Selector
FUNC.LIST
Pos1
[AIL≥FLP M]◊0
Pos0: 0%
CRU
LAU
POS1
POS0
DIFFEREN.
[DIFFEREN.]
◊
CRUISE
LAUNCH
LAND
the Selector to access the aileron-to-flap values. With
the flight mode switch in the upper launch position, move
the aileron control stick full right and hold while adjusting
the aileron-to-flap value by rotating the Selector until the
desired mix is achieved. Press the
to the Function Mode screen.
.
Pos1:+ 16%
LND
AX4
BTF
RUD
is
Selector to achieve the desired aileron differential for
launch. Pressing the Selector will store the value. Now
rotate the Selector to highlight the launch flap value and
adjust it to the desired position. Press the LIST button to
return to the Function Mode screen.
AILE
FLAP
+60%
+40%
+50%
+30%
+20%
0%
button to return
LIST