Step #16 Dual Rate And Exponential; Step #17 Elevator-To-Flap Mix - JR X9303 2.4 Instruction And Programming Manual

Step #16 Dual Rate and Exponential

In , rotate the Selector until
FUNC.LIST
highlighted. Press the Selector to access the Dual Rate
and Exponential menu. Rotate the Selector to highlight
the channel (aile, elev or rudd) then press the Selector
to select the desired channel that you wish to adjust the
dual and expo rates for. Rotate to select then press the
Selector to store the desired channel.
Note that three and
D/R EXPO
available (Pos0, 1 and 2). Under
screen, rotate the Selector until
press the Selector. Select
for the launch mode by rotating the Selector and then
pressing the Selector when

Step #17 Elevator-to-Flap Mix

This function is normally not used in launch mode. It will
be addressed in setting up the Cruise mode below.
D/R & EXP
positions (values) are
on the right of the
AUTO
is highlighted and
LAUN
as the active position
Pos0
is highlighted. This
Pos0
[D/R & EXP]◊0
AILE
POS-0
POS-1
POS-2
is will automatically access dual rate and expo values that
are programmed into position 0 whenever the launch
mode is selected. Now rotate the Selector to Pos0
and depress the Selector to highlight the D/R values.
Rotating the Selector changes these values. Displacing
the aileron stick right or left allows the dual rate to be
independently adjusted in each direction. Depress the
Selector to store the desired D/R values. Rotate the
Selector to the
in the same manner pressing the Selector to store the
desired value.
Now go back to channel and do the same thing for the two
remaining channels. Press the
Function Mode screen.
D/R EXP
110% 30
110% 30
125% 30
125% 30
125% 30
125% 30
values and adjust these values
EXP Pos0
button to return to the
LIST
AUTO
CRUI:0
LAUN:1
LAND:2
S-51