Oki OKIFAX 5400 Maintenance Manual page 70

T.F.
No.
17 T2, timeout value
18 DIS bit32
19 Error criterion
20 Off-hook bypass
21 NL equalizer
40838301TH Rev.1
Table 2.9.1 (4/6) Service Personnel Initial Settings
Item
T2, timeout value
Registers the time duration (in seconds) for
which the receiving fax detects the EOL (End Of
Line) signal during phase C. The fax will discon-
nect the line when EOL cannot be detected
within T2.
* Selects the 3 digit timer
Selects whether a called fax should transmit DIS
bit 32 or not.
ON :
OFF:
When OFF, the following functions will not be
supported:
• Reception of Extra Fine (8 x 15.4 line/mm)
• 300 dpi
• SEP/SUB frame
Note:
Registers the threshould value whether to trans-
mit RTN or MCF signal when the error occurs in
received data.
Switches the function of maintaining communi-
cation without hooking up the telephone set in
normal testing etc.
ON :
OFF:
Selects equalization for the following cable
lengths:
Note:
Specifications
001 to 255 selectable. (in 100ms steps)
For example: 060 x 100 ms =6 s
Transmits a bit 32.
Does not transmit DIS bit 32.
To improve compatibility between this
fax machine and other company's fax
machines. If communication error oc-
curs frequently when a fax sender is an
older version.
00% to 99% selectable. (in one percent steps)
Enable
Disable
0 km/1.8 km/3.6 km/ 7.2 km selectable.
Relative to 1700Hz for length of 0.4mm
diameter cable.
Equalizer level is the difference of gain
of equalized signal between 0.3 kHz
and 3.4 kHz.
2 - 24
Default