Oki OKIFAX 5400 Maintenance Manual page 69

T.F.
No.
11 Long document SCAN
12 Tone for Echo
13 MH only
14 High-speed modem rate
15 T1 (TX), timeout value
16 T1 (RX), timeout value
40838301TH Rev.1
Table 2.9.1 (3/6) Service Personnel Initial Settings
Item
Switches the function of transmitting long-size
document (more than 380 mm).
ON :
OFF :
Switches the function to apply to poor lines with
echo in overseas transmission, etc.
ON:
OFF:
Switches the function of limiting image compres-
sion only to the MH codes.
ON :
OFF :
Specifies the modem's starting speed, 33.6K,
28.8K, 14.4k, 9.6k, or 4.8kbps.
Note:
T1 (TX) is a time to detect up to 3 flags of DIS sent
from a called fax machine.
Registers the time duration (in seconds) for
which the fax waits for the remote station's
answer.
This timer starts when the last dialled digit has
been sent in the automatic transmission mode.
* Selects the 3 digit timer
T1 (RX), timeout value (later)
Registers the time duration (in seconds) for
which the fax waits for the remote station's
answer of individual country's specification. T1
timer starts after the DIS is transmitted. If T1
times out, the fax disconnects the line.
* Selects the 3 digit timer
Specifications
Unlimited (1500 mm)
380 mm.
Enables
Disables
Echo Protection OFF
Ignore 1st DIS OFF
CED-DIS timer 75 ms
Tone for echo OFF
(TF-12 table)
Coding scheme is MH only. When the
receiving image data is affected by
noise on the telephone line.
Any of MH, MR and MMR.
33.6 kbps (V.34) operation is available
when V.34 optional Modem board is
installed and serviceman set enable.
010 to 255 sec selectable.(in one second
steps)
010 to 255 sec selectable. (in one second
steps)
2 - 23
Default
ON
ON
1.5 sec
ON