Notes To Users; Identifying The Packaged Contents; Required Devices; Connectable Peripheral Equipment - Oki OKIFAX 5400 Maintenance Manual

1.

Notes to Users

1.1

Identifying the Packaged Contents

Before using this system, the packaged contents with the package list. Contact your dealer if any
component from the package.
1.2

Required Devices

The following devices and software are required to operate this system.
Personal computer
Internal memory
Extended memory
Fixed disk drive
Display
FX-050 series
facsimile
PC-I/F card
RS-232C cable
Telephone line
Operating system
This system requires ANSI.SYS for screen control.
Confirm the following line in the CONIG.SYS file, if not found please add to write the command.
DEVICE=C:¥DOS¥ANSI.SYS
This system uses EMS memory. In case of memory manager consisted of those EMM386.EXE or
similar types is used by configuration without EMS function, you should remark it does not work.
EXP.: DEVICE=C:¥DOS¥EMM386.EXE NOEMS
Cannot use in settings of the COM port which connect to PC-I/F excluding default.
COMx
COM1
COM2
COM3
COM4
1.3

Connectable Peripheral Equipment

Printer
Mouse
Telephone
To use a mouse, a mouse driver program ia required. This program is automatically incorporated by
the installation program.
40838301TH Rev.1
IBM PC/AT or compatible model
300KB or more
1MB or more
20MB or more
CGA/EGA/VGA type
P050 (Ver.PA2 or later)
25-pin female connector
Public telephone line or two-way local channel
PC-DOS Ver.3.1 or later
SERIAL PORT
START ADDRESS
3F8
2F8
3E8
2E8
Microsoft mouse or equivalent
G - 2
SERIAL PORT
IRQ
END ADDRESS
3FF IRQ4
2FF
IRQ3
3EF IRQ4
2EF IRQ3