Oki OKIFAX 5400 Maintenance Manual page 435

2) Enter the directory name with up to eight alphanumeric characters.
3) Register a password of up to 15 alphanumeric characters excluding [\],["]. If the system oprator
is not defined, password registration not required.
4) When you use RMCS Model 10, set the dip switches on the RMCS card. Normally, you need
only press [Enter]. When an other extention slot and conflicting address space are being used,
change the address space with the dip switches, then set the contents by using 1 and 0.
When you use RMCS Model 20, you need only press [Enter].
OFF corresponds to 1 and ON to 0. Therefore set the dip switches to 11000000 in the following
case.
40838301TH Rev.1
Remote Management Center System
<< RMCS SETTING >>
HARD DISK DRIVE
DIRECTORY
PASSWORD
Press the Esc key to cancel.
Remote Management Center System
<< RMCS SETTING >>
HARD DISK DRIVE
DIRECTORY
PASSWORD
DIPSW (ON:0 OFF:1)
(For RMCS Model 10 only)
Press the Esc key to cancel.
G - 6
= [C]
= [C:\RMCS ]
= [_ ]
= [C]
= [C: RMCS ]
= [ ]
= [11000000]