Folding Mirror Cover - Barco Galaxy NH-12 Service Manual

4. Covers
Image 4-30
Lamp start cover: installing procedure
2. Slide the bottom feet of the cover in their slots by lifting the cover (see 3 on the picture above)
3. Tilt the cover until it is in almost vertical position (see 4 on the picture above)
4. Slide the cover towards the front side of the projector to lock the feet (see 5 on the picture above)
5. Tilt the cover until it closes the lamp start housing (see 6 on the picture above)
6. Use two screws to fix the cover
Image 4-31
4.6

Folding mirror cover

Overview
• Removing the folding mirror cover
• Installing the folding mirror cover
Introduction
The folding mirror cover gives access to the following modules:
• folding mirror and its adjusting screws
• CLO-LFR assembly
Before the lamp start cover can be taken off, the rear cover of the projector must be removed. See the con-
cerning chapter to remove/install the rear cover.
24
1
4
2
5
R59770141 GALAXY NH-12 20/02/2008
3
6