Installing The Input Module - Barco Galaxy NH-12 Service Manual

Image 7-69
Input module: fixing screws front
7. Remove the three screws fixing the input module to the chassis
Image 7-70
Input module; fixing screws chassis
8. Lift the input module a bit and unplug the connectors on the PMP:
- J15: power supply from the power box
- J19: IC2 to the desktop input
- J23; I2C from the power box
- J14: sync from the engine controller
- J22: I2C to the engine controller
- J11: ethernet wire from the front panel
- J2 and J3 on the LVDS interface (which is mounted on the PMP): data from the desktop input
9. Remove the input module
7.7.3

Installing the input module

Necessary tools
Torx screwdriver T10
How to install the input module?
1. Put the connector next to its correct position and plug in the connectors:
- J15: power supply from connector 6 on the power box
- J19: IC2 to connector J320 on the desktop input
- J23; I2C from connector 13 on the power box
- J14: sync from connector J4 on the engine controller
- J22: I2C to connector J5 on the engine controller
- J11: ethernet wire from the front panel
- J2 and J3 on the LVDS interface (which is mounted on the PMP): data from connectors J200 and J300 on the desktop input
2. Lower the input module until it is in its final position and fix it using three fixing screws
R59770141 GALAXY NH-12 20/02/2008
7. Electronic parts and servicing procedures
71