Optional Input Layer; Removing The Optional Input Layer; Installing The Optional Input Layer - Barco Galaxy NH-12 Service Manual

7.7.4.5.1

Optional input layer

Description
There is a free slot in the input module where an analog input layer or a DVI / D15 input layer can be mounted.
Image 7-103
Optional input layer
7.7.4.5.2

Removing the optional input layer

Necessary tools
Torx screwdriver T10
How to remove the optional input layer?
1. Remove the cover (see concerning chapters):
- rear cover
- front cover
2. Remove the screws fixing the optional input layer to the front panel
3. Remove the side screw fixing the optional input layer to the PMP
Note: This screw can be reached from the left side of the projector without taking out the input module.
4. Unplug the board-to-board connectors by pulling the optional input board to the right side
5. Slide the optional input layer out of the input module
7.7.4.5.3

Installing the optional input layer

Necessary tools
Torx screwdriver T10
How to install the optional input layer?
1. Remove the covers (see concerning chapters)
- rear cover
- front cover
2. If there is a blank cover plate present, remove it by unscrewing both fixing screws
R59770141 GALAXY NH-12 20/02/2008
7. Electronic parts and servicing procedures
85