7. Electronic parts and servicing procedures
Image 7-86
DVI / D15 input layer: side screw
3. Fix the input board to the front panel using four bolts
Image 7-87
DVI / D15 input layer: front screws
4. Install the input module (see concerning chapter)
7.7.4.3
Output and communication layer
Overview
•
Description of the output and communication layer
•
Removing the output and communication layer
•
Installing the output and communication layer
7.7.4.3.1
Description of the output and communication layer
Description
The output and communication layer has a multiple functionality:
•
IR receiver (front side of the projector): receives commands from the remote control (RC) and forwards them to the processor
of the PMP
•
wired RC (remote control): receives commands from the wired remote control (RC) and forwards them to the processor of the
PMP
•
RS232 serial connector: to control the projector
•
DVI output: image as it leaves the PIP on the PMP. Not enabled in case of stereo
Monitors connected to the DVI output may show a bad image if Full screen representation is ON in the OSD
(see User's Guide for details on how to toggle between ON and OFF)
78
R59770141 GALAXY NH-12 20/02/2008