Image 7-61
Lamp power supply: power cables
7. Remove both screws fixing the SPG
Image 7-62
SPG: fixing screws
8. Remove the SPG by pulling it out of its housing
Tip:
If the lamp has been removed (see step 3), it will be easier to remove the SPG by pushing the electrodes to slide it out,
rather than just pulling it out.
Caution:
While pulling out the SPG, make sure the power cables do not get stuck!
7.6.4
Installing the SPG
Necessary tools
•
Torx screwdriver T10
•
Nut spanner 10 mm
•
Allen key 4 mm
How to install the SPG?
1. Guide the power cables underneath the lamp to the LPS
2. Put in the SPG in its housing and push it into its sockets
R59770141 GALAXY NH-12 20/02/2008
7. Electronic parts and servicing procedures
67