7. Electronic parts and servicing procedures
7.15 Motor connector board
Description of the motor connector board
The motor connector board is an interconnection board between the power box or engine controller on the one hand and the lens
motors, lens holder motors and end of course switches on the lensholder on the other hand.
Necessary tools
Torx screwdriver T10
How to remove the motor connector board?
1. Remove the covers (see concerning procedure):
-
rear cover
-
top cover
-
engine fan cover 1
2. Disconnect the motor connector board
Image 7-155
Motor connector board: location
3. Remove the screws fixing the motor connector board to the lens holder
Image 7-157
Motor connector board: fixing screws
4. Remove the motor connector board
How to install the motor connector board?
1. Put the motor connector board in the correct position
2. Fix the motor connector board to the lens holder using two screws
108
1
2
3
4
5
Image 7-156
Motor connector board: connectors
1
microswitch left-right
2
microswitch up-down
3
motor left-right (green)
4
lens focus (orange)
5
motor up-down (black)
R59770141 GALAXY NH-12 20/02/2008