Installing The Lps; Replacing The Light Feedback Board - Barco Galaxy NH-12 Service Manual

7. Electronic parts and servicing procedures
Image 7-50
LPS: location of the fixing screws
5. Lift the LPS to remove it
7.5.3

Installing the LPS

Necessary tools
• Torx screwdriver T10
• Torx screwdriver T20
• nut spanner 10 mm
How to install the LPS?
1. Put the LPS in its correct position
2. Fix it using three fixing screws
Image 7-51
LPS: location of the fixing screws
3. Plug in / connect the wires
- use two nuts M6 to fix the wires to the lamp and to the SPG
- plug in both wires coming from the mains power (Faston connectors)
- plug in both wires coming from the engine controller (LFR + I2C)
Caution: Pay attention to the polarity!
4. Install the lamp power cover (see concerning chapter)
5. Install the fan outlet (see concerning chapter)
6. Install the covers (see concerning chapters):
- top cover
- rear cover
7.5.4

Replacing the Light feedback board

Necessary tools
Trox screwdriver T10
62 R59770141 GALAXY NH-12 20/02/2008